For Stylus Cleaner USAGE instruction - go to the bottom of this page.
TRU-LIFT Automatic Tone Arm Lift Lifter
SET UP INSTRUCTION "HOW TO" VIDEOS.
TRU-LIFT Automatic Tone Arm Lift Lifter
SET UP INSTRUCTION "HOW TO" VIDEOS.
1. Choosing The Right TRU-LIFT for your table - Watch video below.
TRU-LIFT SET UP
2. Step by Step instructions on how to correctly set up on your table after purchase - See Guide below from A-E.
2. Step by Step instructions on how to correctly set up on your table after purchase - See Guide below from A-E.

A. Measuring the distance between plinth & tonearm. With the platter stopped & the needle sitting down on the record (still position), measure the distance from the top of the turntable plinth to the underside of tonearm.
B. Allowing for clearance between tonearm & TRU-LIFT. (As shown in the picture B - reduce 1/16" from picture A). Reference picture A - measures 1.5" & picture B is reduced to 1 7/16".
C. With the Supplied Allen Key - Loosen set screw on the side of the TRU-LIFT and raise to desired height.
D. Aligning TRU-LIFT with the runout groove. ( please refer to the "yellow laser line").
IMPORTANT / CAUTION: Platter must be in STOPPED POSITION to proceed with the next step.
E. With the Tonearm cued up and TRU-LIFT in the ready primed position, Place TRU-LIFT between the tonearm base & the record. (Tonearm should be touching the "trip Release" antenna at this point).
3. Set up & Placement - Watch video below.
4. Fine Tuning Sensitivity Adjustment - Watch video below
More Videos on "Sensitivity Adjustment"
Summary Video on "Set up" of Tru-Lift
TRU-LIFT PLACEMENT IS VERY IMPORTANT, MAKE SURE THAT FRONT IS FACING TOWARDS YOU.
TRU-LIFT PLACEMENT IS VERY IMPORTANT, MAKE SURE THAT FRONT IS FACING TOWARDS YOU.
